WSF_SLC_DEGRADE_EFFECT

effect WSF_SLC_DEGRADE_EFFECT

effect <effect-name> wsf_slc_degrade_effect
   ... base effect commands ...
   ... wsf_radius_effect commands ...
   ... wsf_repeater_effect commands ...
   ... wsf_power_effect commands ...
   ... wsf_radius_effect commands ...
   number_slc_channels_saturated <integer-value>
   signal_modulation <modulation-type>
   slc_degradation_factor <db-ratio-value>
   system_type_data <system-type-name> ... end_system_type_data
end_effect

this base effect type can be included in the electronic_attack technique block as one of the many available effects for a given technique. the commands listed below are the base-type commands that can be specified in the effect block for this effect type.

number_slc_channels_saturated <integer-value>

specifies the number of sidelobe canceler (slc) channels this technique will saturate (occupy).

default: 1

signal_modulation <modulation-type>

specifies the signal modulation used by this technique.

default: none

slc_degradation_factor <db-ratio-value>

specifies the degradation factor to apply to the slc cancellation ratio defined by the WSF_SLC_EFFECT.

system_type_data <system-type-name> … end_system_type_data

input block to provide the system type (e.g., sensor-type, jammer-type) specific data necessary to implement this technique for a given system type. Default data can be set up for system types not defined using the “default” string as the system type.

system_type_data <system-type-name>
   WSF_RADIUS_EFFECT Commands
   WSF_REPEATER_EFFECT Commands
   WSF_POWER_EFFECT Commands
   WSF_RADIUS_EFFECT Commands
   number_slc_channels_saturated <integer-value>
   signal_modulation <modulation-type>
   slc_degradation_factor <db-ratio-value>
end_system_type_data

<system-type-name>

A string input of the system-type the following data applies to, valid values are [system-type-name | “default”]. Default data is used for unspecified system-types and if not defined no effect will be applied for the given system-type.